Toyota 1996 LAND CRUISER User Manual page 1080

SA−18
90°
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE
(h) Install the 2 plate washers and bolts.
Torque: 96 N·m (980 kgf·cm, 71 ft·lbf)
6. MEASURE BEARINGS PRELOAD
Using a spring tension gauge, measure the preload.
Preload (at starting):
25 − 44 N (2.5 − 4.5 kgf, 5.6 − 9.9 lbf)
7. ADJUST BEARING PRELOAD
(a) Remove the bearing cap and knuckle arm
(See page SA−13).
(b) Select the adjusting shim.
Adjusting shim thickness
R13138
(c) Install the bearing cap and knuckle arm
(See page SA−17).
8. CONNECT TIE ROD TO KNUCKLE ARM
Torque the nut and secure it with a new cotter pin.
Torque: 91 N·m (925 kgf·cm, 67 ft·lbf)
9. INSTALL OIL SEAL END RETAINER TO KNUCKLE
ARM
Install the oil seal end retainer to steering knuckle with the 6
bolts.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
10. INSTALL AXLE SHAFT
Position one flat part of the outer shaft upward and install the
shaft.
11. PACK MOLYBDENUM DISULFIDE LITHIUM BASE
GREASE, NLGI NO.2
Pack molybdenum disulfide lithium base grease, NLGI No.2
into the knuckle to about 3 fourths of the knuckle.
Molybdenum
12. INSTALL KNUCKLE SPINDLE, DUST COVER WITH
Disulfide
Lithium
GASKETS AND DUST SEAL
Base Grease
(a) Place a new gasket in the position on the knuckle and
NIGI No.2
install the spindle.
(b) Place the dust cover, dust seal and a new gasket on the
Z15222
spindle.
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− STEERING KNUCKLE AND AXLE SHAFT
Thickness mm (in.)
0.1 (0.004)
0.2 (0.008)
Thickness mm (in.)
0.5 (0.020)
1.0 (0.039)