Fulcrum Length
SST
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SFI
8.
(a)
(b)
(c)
30 cm
NOTICE:
Do not rotate the fuel pipe, when tightening the flare nut.
FI1654
HINT:
Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
Brought to you by BirfMark
Version 1.00 - 12/21/2010
−
SFI SYSTEM
FUEL SYSTEM
When disconnecting the high fuel pressure line, a large
amount of gasoline will spill out, so observe the following
procedures:
(1)
Disconnect the fuel pump connector.
(2)
Start the engine. After the engine has stopped on
its own, turn off the ignition switch.
(3)
Put a container under the connection.
(4)
Slowly loosen the connection.
(5)
Disconnect the connection.
(6)
Plug the connection with 2 rubber plugs.
(7)
Reconnect the fuel pump connector.
When connecting the union bolt on the high pressure pipe
union, observe the following procedures:
(1)
Always use a new gasket.
(2)
Tighten the union bolt by hand.
(3)
Tighten the union bolt to the specified torque.
Torque: 29 N·m (300 kgf·cm, 21 ft·lbf)
When connecting the flare nut on the high pressure pipe
union, observe the following procedures:
(1)
Apply a light coat of engine oil to the flare and tight-
en the flare nut by hand.
(2)
Using SST, tighten the flare nut to the specified
torque.
SST
09631−22020
Torque: 30 N·m (310 kgf·cm, 22 ft·lbf)
Author :
SF−3
Date :
631