Toyota 1996 LAND CRUISER User Manual page 1349

TR−6
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
TRANSFER −
11. REMOVE RETAINER FROM REAR CASE
Remove the 5 bolts and retainer.
Torque: 39 N·m (400 kgf·cm, 28 ft·lbf)
12. REMOVE ADJUSTING SHIM
HINT:
At the time of assembly, select adjusting shims for the idler gear
rear taper roller bearing.
(a) Using vernier calipers, measure dimension A.
(b) Lightly hold down the bearing outer race in the thrust
direction to eliminate any looseness before making the
measurement.
(c) Using a steel straight edge and feeler gauge, measure
B
the clearance of dimension B.
(d) Calculate the required thickness of the adjusting shim.
Thickness:
Dimension A + Dimension B + (0.022 − 0.049 mm,
0.0009 − 0.0019 in.)
(e) From the following table, select a shim so that its thick-
ness is within the range of the calculation.
Z18976
Mark
2
3
4
5
6
7
HINT:
C At the time of reassembly, select adjusting shims for the output
shaft taper roller bearing.
(f) Using a steel straight edge and feeler gauge, measure
the clearance of dimension C.
(g) Lightly hold down the bearing outer race in the thrust
direction to eliminate any looseness before making the
measurement.
(h) Calculate the required thickness of the adjusting shim.
Z18977
Brought to you by BirfMark
Version 1.00 - 12/21/2010
TRANSFER ASSEMBLY
Thickness mm (in.) Mark
0.30 (0.0118)
0.45 (0.0177)
2.40 (0.0945) 10
2.60 (0.1024)
2.80 (0.1102) 12
3.00 (0.1181) 13
Thickness mm (in.)
8 3.20 (0.1260)
9 3.40 (0.1339)
3.60 (0.1417)
11 3.80 (0.1496)
4.00 (0.1575)
0.55 (0.0216)