Toyota 1996 LAND CRUISER User Manual page 1037

RS−14
SUPPLEMENTAL RESTRAINT SYSTEM
Connector
Stripped Wire Harness Section
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
2.
NOTICE:
S
S
HINT:
Have a battery ready as the power source to deploy the airbag.
(a)
CAUTION:
When storing the steering wheel pad, keep the upper sur-
face of the pad facing upward.
(b)
(c)
Wire Harness
Diameter
HINT:
To calculate the square of the stripped wire harness section:
Square = 3.14 x (Diameter)
CAUTION:
If a wire harness which is too thin or some other thing is
AB0163
used to tie down the steering wheel pad, it may be snapped
by the shock when the airbag is deployed. This is highly
dangerous. Always use a wire harness for vehicle use
which is at least 1.25 mm
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− STEERING WHEEL PAD AND SPIRAL CABLE
DEPLOYMENT WHEN DISPOSING OF STEERING
WHEEL PAD ONLY
When disposing of the steering wheel pad (with air-
bag) only, never use the customers vehicle to deploy
the airbag.
Be sure to follow the procedure given below when de-
ploying the airbag.
Remove the steering wheel pad (See page SR−11).
Remove the connector on the rear surface of the steering
wheel pad from the bracket.
Using a service−purpose wire harness, tie down the
steering wheel pad to the disc wheel.
Wire harness: Stripped wire harness section
2
1.25 mm or more (0.0019 in
2
2
2
or more).
divided by 4
2
(0.0019 in ).