Toyota 1996 LAND CRUISER User Manual page 1264

SR−14
SST
SST
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
STEERING − TILT STEERING COLUMN
10. REMOVE COLUMN UPPER TUBE WITH MAIN SHAFT
ASSEMBLY
(a) Set SST, the nut (10 mm nominal diameter, 1.25 mm
pitch), plate washer (36 mm outer diameter) and bolt (10
mm nominal diameter, 1.25 mm pitch, 50 mm length), as
shown.
SST 09910−00015 (09911−00011, 09912−00010)
Reference
Nut: 90170−10004
Plate washer: 90201−10201
Bolt: 91111−51050
(b) Remove the 2 tilt No.2 bolts by using the sliding hammer
on SST.
(c) Remove the upper tube with the shaft assembly from the
column lower tube.
11. REMOVE TURN SIGNAL BRACKET
Remove the 2 bolts.
12. REMOVE MAIN SHAFT ASSEMBLY
(a) Using SST, compress the compression spring.
SST 09950−40010 (09957−04010, 09958−04010)
NOTICE:
Do not bend the sliding yoke of the main shaft assembly
more than 20°.
(b) Using snap ring pliers, remove the snap ring.
(c) Remove the shaft assembly from the column upper tube.
(d) Remove the compression spring, bearing thrust collar
R09496
and bearing from the shaft assembly.
13. REMOVE COLLAR
Remove the snap ring and collar from the column lower tube.
Brought to you by BirfMark
Version 1.00 - 12/21/2010