Toyota 1996 LAND CRUISER User Manual page 1143

1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE
5. CHECK SIDE GEAR BACKLASH
Using a dial indicator, measure the side gear backlash with
holding one pinion gear toward the case.
Backlash: 0.02 − 0.20 mm (0.0008 − 0.0079 in.)
If the backlash is not within the specification, install the correct
thrust washers (See page SA−87).
6. CHECK TOOTH CONTACT BETWEEN RING GEAR
AND DRIVE PINION (See page SA−35)
7. w/ DIFFERENTIAL LOCK:
REMOVE INDICATOR SWITCH
Remove the indicator switch and gasket.
8. w/ DIFFERENTIAL LOCK:
REMOVE COVER
(a) Remove the 3 bolts.
(b) Using a brass bar and hammer, tap on the cover to re-
move it.
9. w/ DIFFERENTIAL LOCK:
REMOVE SLEEVE
(a) Remove the 4 bolts.
(b) Using a plastic hammer, tap the actuator.
(c) Remove the actuator and sleeve.
SA2131
10. w/ DIFFERENTIAL LOCK:
REMOVE ACTUATOR AND SHIFT FORK AND SHAFT
(a) Remove the shift fork shaft bolt.
(b) Pull out the actuator and remove the shift fork.
SA2134
11. REMOVE COMPANION FLANGE
SST
(a) Using a chisel and hammer, unstick the nut.
(b) Using SST to hold the flange, remove the nut and plate
washer.
SST
SA2448
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− REAR DIFFERENTIAL CARRIER
09330−00021
SA−81