Toyota 1996 LAND CRUISER User Manual page 1175

1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE −
REMOVAL
1. REMOVE REAR WHEEL
Torque:
Steel wheel: 147 N·m (1,500 kgf·cm, 109 ft·lbf)
Aluminum wheel: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
2. REMOVE REAR SHOCK ABSORBER
(a) Remove the lower bolt holding the shock absorber from
the rear axle housing.
Torque: 64 N·m (650 kgf·cm, 47 ft·lbf)
(b) Remove the retainer and 2 cushions, disconnect the
shock absorber.
(c) Remove the 2 upper bolts and shock absorber.
Torque: 50 N·m (510 kgf·cm, 37 ft·lbf)
(d) Remove these parts from the shock absorber:
S
S
S
S
Torque: 69 N·m (700 kgf·cm, 51 ft·lbf)
3. DISCONNECT STABILIZER BAR BRACKETS FROM
REAR AXLE HOUSING (See page SA−124)
4. DISCONNECT LATERAL CONTROL ROD FROM
REAR AXLE HOUSING (See page SA−118)
5. REMOVE COIL SPRING
(a) Begin to lower the axle housing.
HINT:
Be careful not to snap the brake line and parking brake cable.
R08418
(b) With lowering the rear axle housing, remove the coil
spring and insulator.
HINT:
Check that the coil spring end is installed correctly.
If the coil spring end is not in the correct position, reinstall the
coil spring.
Brought to you by BirfMark
Version 1.00 - 12/21/2010
COIL SPRING AND REAR SHOCK ABSORBER
Nut
3 Retainers
2 Cushions
Bracket
SA−113
SA1VP−01