Toyota 1996 LAND CRUISER User Manual page 1100

SA−38
Boiling Water
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE −
5. INSTALL SIDE BEARINGS
w/o Differential lock:
S
Using SST and a press, install the 2 side bearings on the
differential case.
SST
w/ Differential lock:
S
Using SST and a press, install the 2 side bearings on the
differential case.
SST
6. INSTALL RING GEAR ON DIFFERENTIAL CASE
(a) Clean the contact surfaces of the differential case and
ring gear.
(b) Heat the ring gear to about 100°C (212°F) in boiling wa-
ter.
(c) Carefully remove the ring gear from the water.
(d) After the moisture on the ring gear has completely evapo-
rated, quickly install the ring gear to the differential case.
(e) Align the matchmarks on the ring gear and differential
SA2160
case.
(f) Temporarily install new 5 lock plates and 10 set bolts.
NOTICE:
The ring gear set bolts should not tighten until the ring gear
has cooled sufficiently.
(g) After the ring gear cools down enough, tighten the set
bolts uniformly and a little at a time.
Torque: 97 N·m (985 kgf·cm, 71 ft·lbf)
SA2178
(h) Using a drift punch and hammer, stake the lock plates.
HINT:
Stake one claw flush with the flat surface of the bolt. For the
claw contacting the protruding portion of the bolt, stake only the
half on the tightening side.
SA2182
Brought to you by BirfMark
Version 1.00 - 12/21/2010
FRONT DIFFERENTIAL CARRIER
09950−60010 (09951−00480)
09223−15020, 09950−60010 (09951−00480)