Toyota 1996 LAND CRUISER User Manual page 1282

SR−30
Press
Socket
Wrench
Inscribed Mark
Round End
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
STEERING − POWER STEERING VANE PUMP
REASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1. COAT WITH POWER STEERING FLUID
(See page SR−21)
2. INSTALL VANE PUMP SHAFT WITH BEARING
(a) Using a socket wrench (29 mm), press in the shaft with the
bearing to the front housing.
NOTICE:
R08080
Be careful not to damage the oil seal lip.
(b) Using snap ring pliers, install a new snap ring to the front
housing.
3. INSTALL LONGER STRAIGHT PIN
Install a new pin to the front housing.
NOTICE:
Be careful not to damage the pin.
4. INSTALL SIDE FRONT PLATE
(a) Coat 2 new O−rings with power steering fluid and install
them to the plate.
(b) Align the hole of the plate and longer straight pin.
NOTICE:
Make sure you install the plate facing the correct direction.
(See page SR−21)
5. INSTALL SHORTER STRAIGHT PIN
Install a new pin to the side front plate.
NOTICE:
Be careful not to damage the pin.
6. INSTALL CAM RING AND VANE PUMP ROTOR
R08098
Install the ring and rotor with the inscribed marks facing out-
ward.
7. INSTALL VANE PLATES
Install the 10 plates with the round end facing outward.
8. INSTALL SIDE REAR PLATE
(a) Coat a new O−ring with power steering fluid and install it
to the plate.
(b) Align the holes of the plate with the straight pins.
R08081
Brought to you by BirfMark
Version 1.00 - 12/21/2010
SR16J−01