Toyota 1996 LAND CRUISER User Manual page 1050

SUPPLEMENTAL RESTRAINT SYSTEM
Stripped Wire Harness Section
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
(e)
CAUTION:
S
S
S
S
2.
NOTICE:
S
S
HINT:
Have a battery ready as the power source to deploy the airbag.
(a)
CAUTION:
S
S
(b)
Wire Harness
Diameter
HINT:
To calculate the square of the stripped wire harness section:
AB0163
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− FRONT PASSENGER AIRBAG ASSEMBLY
Dispose of the front passenger airbag assembly.
The front passenger airbag assembly is very hot
when the airbag is deployed, so leave it alone for at
least 30 minutes after deployment.
Use gloves and safety glasses when handling a front
passenger airbag assembly with deployed airbag.
Always wash your hands with water after completing
the operation.
Do not apply water, etc. to a front passenger airbag
assembly with deployed airbag.
(1) When scrapping a vehicle, deploy the airbag and
scrap the vehicle with the front passenger airbag
assembly still installed.
(2) When moving a vehicle for scrapping which has a
front passenger airbag assembly with deployed air-
bag, use gloves and safety glasses.
DEPLOYMENT WHEN DISPOSING OF FRONT PAS-
SENGER AIRBAG ASSEMBLY ONLY
When disposing of the front passenger airbag assem-
bly only, never use the customer's vehicle to deploy
the airbag.
Be sure to follow the procedure given below when de-
ploying the airbag.
Remove the front passenger airbag assembly.
(See page RS−22)
When removing the front passenger airbag assembly,
work must be started 90 seconds after the ignition
switch is turned to the "LOCK" position and the nega-
tive (−) terminal cable is disconnected from the bat-
tery.
Store the front passenger airbag assembly with the
airbag deployment side facing upward.
Using a service−purpose wire harness for the vehicle, tie
down the front passenger airbag assembly to the tire.
Wire harness: Stripped wire harness section
2
1.25 mm or more (0.0019 in.
Square = 3.14 X (Diameter)
RS−27
2
or more)
2
divided by 4