Toyota 1996 LAND CRUISER User Manual page 1020

PR−6
Matchmarks
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
PROPELLER SHAFT
SPIDER BEARING
REPLACEMENT
NOTICE:
Be careful not to grip the propeller shaft tube too tightly in
the vise as this will cause deformation.
1. REMOVE PROPELLER SHAFT (See page PR−3)
2. PLACE MATCHMARKS ON SHAFT AND YOKE
PR0058
3. REMOVE SNAP RINGS
(a) Using a brass bar and hammer, slightly tap in the bearing
outer races.
(b) Using 2 screwdrivers, remove the 4 snap rings from the
grooves.
Z00753
4. REMOVE SPIDER BEARINGS
(a) Using SST, push out the bearing from the flange.
SST
HINT:
SST
Sufficiently raise the part indicated by A so that it does not come
A into contact with the bearing.
PR0060
(b) Clamp the bearing outer race in a vise and tap off the
flange with a hammer.
HINT:
Remove the bearing on the opposite side by the same proce-
dure.
PR0061
(c) Install the 2 removed bearing outer races to the spider.
(d) Using SST, push out the bearing from the yoke.
SST
(e) Clamp the outer bearing race in a vise and tap off the yoke
with a hammer.
HINT:
SST
Remove the bearing on the opposite side in the same proce-
dure.
Z00754
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− SPIDER BEARING
09332−25010
09332−25010
Author :
PR06S−03
Date : 854