Compartment (Estate); Removable Light; Class N1 Vehicles; Variable Loading Floor In The Luggage Compartment (Estate) - Skoda 2014 Yeti Owner's Manual

Removable light

Fig. 102 Light operation / removal

Read and observe and
A removable light is fitted on the right side of the boot. This lamp has two
functions.
›
Lighting the luggage compartment - part
holder).
›
Portable light - part is illuminated (light removed from the holder).
A
The lamp is fitted with magnets. Therefore it is possible to attach the lamp, for
example on the vehicle body, after removing it.
Using the system
›
If you press button » Fig. 102
C
ty.
›
If you press button again, the lamp lights up with 50 % light intensity.
C
›
Press button once again - the light goes out.
C
Removed from the holder
›
Grasp the lamp in the areas of the arrow
direction of the arrow .
1
Reinserting the lamp the holder
›
Switch off the ignition » .
›
First of all, place the deactivated light in the holder on the side facing the
boot lid and then press on the light from the other side until it is clicks into
place.
The lamp is supplied by three rechargeable type AAA batteries. The rechargea-
ble batteries are constantly charged when the engine is running. It takes ap-
prox. 3 hours to fully charge the rechargeable batteries.
100
Using the system
on page 94 first.
» Fig. 102 illuminated (lamp in
B
, the lamp lights up with 100 % light intensi-
» Fig. 102 and swivel it in the
D
Replace batteries » page 204.
Luggage compartment light
If the light is in the holder, it is automatically switched on when the boot lid is
opened.
If the lamp is in the holder, it is automatically switched off when the boot lid is
closed.
CAUTION
The removable lamp is not watertight and must therefore be protected
■
against moisture.
If the lamp is not switched off and it is correctly inserted in the holder, the
■
bulbs in the front part » Fig. 102
A
If the lamp is not correctly inserted into the holder, it does not light up when
■
the boot lid is opened and the rechargeable batteries are not charged.

Class N1 vehicles


Read and observe and
On class N1 vehicles, which are not fitted with a protective grille, a lashing set
which complies with the standard EN 12195 (1 - 4) must be used for fastening
the load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.

Variable loading floor in the luggage compartment (Estate)


Introduction
This chapter contains information on the following subjects:
Removing and inserting the variable loading floor
Securing the loading floor in the raised position
Removing and refitting carrier rails
Using the variable loading floor with a spare wheel
The variable loading floor makes it easier to handle bulky goods and creates an
even boot floor when the rear seat backrests are folded forward.
of the lamp are automatically switched off.
on page 94 first.
101
101
101
102
