Automatic Transmission - Skoda 2014 Yeti Owner's Manual

Hide thumbs Also See for 2014 Yeti:
Table of Contents

Advertisement

In the driver's footwell, only a format may be used, which is attached to the
two corresponding attachment points.
Only use factory-supplied foot mats or foot mats from the range of
ŠKODAOriginal Accessories, which are fitted to two attachment points.
WARNING
No objects may be placed in the driver's footwell – risk due to obstruction
or limitation of pedal operation.

Automatic transmission

Introduction
This chapter contains information on the following subjects:
Modes and use of selector lever
Selector lever lock
Manual shifting of gears (Tiptronic)
Starting-off and driving
The automatic transmission performs automatic gear changes.
The modes of the automatic transmission can be adjusted by the driver by
means of the selector lever.
WARNING
No throttle when it is set before starting the mode for moving forward
with the selector lever - there is a risk of accident!
Never move the selector lever to mode R or P when driving – risk of an
accident!
When the vehicle is stationery and the engine is running, you need to
hold the vehicle with the brake pedal in mode D, S or R. Even when the en-
gine is idling, the power transmission is never completely interrupted – the
vehicle creeps.
When leaving the vehicle, the selector lever is always to put in the P
mode. Otherwise the vehicle could then start to move and potentially cause
an accident.
134
Driving
CAUTION
If the selector lever is moved to mode N while driving, the accelerator pedal
must be released and you will need to wait until the engine has reached its
idling speed before moving the selector lever to a forward driving mode again.
When the outdoor temperature is below -10 ° C, the selector lever when
starting must always be in P mode.
When stopping on a slope, never try to hold the vehicle using the accelerator
pedal – this may lead to gear damage.
Note
After the ignition is switched off, the ignition key can only be withdrawn if the
selector lever is in the position P.
Modes and use of selector lever
134
135
135
136
Fig. 124 Selection lever / lock button / display
Read and observe
When the ignition is switched on, the gearbox mode and the currently selected
gear are indicated in the display
The following modes can be selected with the selector lever
– Parking mode
P
The driven wheels are locked mechanically in this mode.
The parking mode must only be selected when the vehicle is stationary.
- Reverse gear
R
Reverse gear can only be engaged when the vehicle is stationary and the en-
gine is at idling speed.
and
on page 134 first.
» Fig.
124.
» Fig.
124.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents