Skoda 2014 Yeti Owner's Manual page 112

■ Activate - Activate pre-set mode
Deactivate - Deactivate pre-set mode
■
Factory settings - Restore factory settings
■
■ Back - Return to main menu
Only one programmed pre-set time can be active.
The last programmed pre-set time remains active.
After the auxiliary heating activates at the set time, it is necessary to pre-set a
time again.
If the pre-set menu is closed by selecting the Back menu item or if no changes
are made on the display for more than 10 seconds, the set values are stored,
but the pre-set time is not activated.
An indicator light on the button  is illuminated when the system is running.
The running system deactivates after expiration of the operating period or can
be deactivated earlier by pressing the button to directly switch on/off the aux-
iliary heating  or by using the radio remote control.
Radio remote control

Read and observe and
Radio remote control » Fig. 113
Aerial
A
Warning light
B
Switch on the auxiliary heating

Switch off the auxiliary heating

The transmitter and the battery are housed in the housing of the remote con-
trol. The receiver is located in the interior of the vehicle.
110
Using the system
Fig. 113
Radio remote control of the aux-
iliary heating
on page 109 first.
When the battery is fully charged, the range of the remote control is a few
hundred metres. Obstacles between the radio remote control and the vehicle,
bad weather conditions and a weaker battery can clearly reduce the range.
To switch the auxiliary heating on or off, hold the remote control vertically,
with the aerial » Fig. 113 pointing upwards. The antenna must not be cov-
A
ered with the fingers or the palm of the hand during this process.
The auxiliary heating can only be switched on/off safely using the radio re-
mote control, if the distance between the radio remote control and the vehicle
is at least 2 m.
After pressing the button, the warning light in the remote control gives the
user different kinds of feedback.
Display warning light » Fig. 113
B
Lights up green for around 2 seconds.
Lights up red for around 2 seconds.
Slowly flashes green for around 2 sec-
onds.
Quickly flashes green for around 2
seconds.
Flashes red for around 2 seconds.
Lights up orange for around 2 sec-
onds, then green or red.
Lights up orange for around 2 sec-
onds, then flashes green or red.
Flashes orange for around 5 seconds.
Replace the battery » page 203.
Meaning
The auxiliary heating has been
switched on.
The auxiliary heating has been
switched off.
The ignition signal was not received.
The auxiliary heating is blocked, e. g
because the tank is nearly empty or
there is a fault in the auxiliary heat-
ing.
The switch off signal was not re-
ceived.
The battery is weak, however the
switching on or off signal was re-
ceived.
The battery is weak, however the
switching on or off signal was not re-
ceived.
The battery is discharged, however
the switching on or off signal was not
received.
