Table of Contents
Advertisement
›
To switch on the removed light, press button
again will switch it off.
›
To insert, first of all insert the light with the rear part
» Fig. 157
and then push the light in the direction of arrow
clicks into place.
If the light is not switched off and is correctly inserted in the mount, the LED
diodes in the front part of the light
If the lamp is not correctly inserted into the holder, this does not light up when
the boot lid is opened and the rechargeable batteries are not charged.
Lamp charges
The lamp is supplied by three rechargeable type NiMH AAA batteries. The bat-
teries are charged continuously with the engine running (to fully charge the
battery takes approximately 3 hours).
Replace batteries
» page
304.
CAUTION
The light is not waterproof, so it must be protected from humidity - otherwise
there is risk of damage.
Class N1 vehicles
Read and observe
and
In class N1 vehicles that are not fitted with a protective grille, a lashing set that
complies with the EN 12195 standard (1-4) must be used for fastening the
load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.
Variable loading floor in the luggage compartment (Estate)
Introduction
In its five-seat variant of the variable loading floor of two panels. The panels
can be handled separately.
In the seven-seat variant of the variable loading floor consists of one panel.
» Fig.
156. Pressing the light
A
into the mount
E
until it audibly
2
» Fig. 156
are automatically switched off.
C
on page 109 first.
Set the variable loading floor to the upper position
Fig. 158 Set the variable loading floor to the upper/lower position
The front and rear panels of the variable loading floor can be set in the upper
or lower position as follows. The handling of the two panels is identical.
›
Raise the variable loading floor by the handle
slide partially in the direction of arrow
›
To set to the upper position, lift the variable loading floor in the front area
and lay on the edge
.
B
›
To set to the lower position slide the variable loading floor in direction of
arrow
. After this has detached from the edge
2
panel on the floor covering of the luggage compartment.
›
Insert the panel in the direction of arrow
of arrow
.
4
in direction of arrow
A
1
.
2
, place the front of the
B
until it stops and lay in direction
3
Transport of cargo
and
115
Advertisement
Table of Contents
