Skoda 2014 Yeti Owner's Manual page 79

Note
If the setting procedure is interrupted, you will need to press the button again.
Memory Function of the electrically adjustable seat

Read and observe on page 75 first.
The memory function for the driver's seat provides the option to store the po-
sitions of the driver's seat and the external mirrors. Each of the three memory
buttons » Fig. 59 can be assigned a set position.
B
Storing seat and exterior mirror settings for driving forward
›
Switch on the ignition.
›
Adjust the seat to the desired position.
›
Adjust both of the exterior mirrors
›
Press the button » Fig.
SET A
›
Within 10 seconds after pressing the
button .
B
An acknowledgement sound confirms the storage.
Saving front passenger mirror settings when reversing
Above the MAXI DOT display in the menu item Mirror down The lowering func-
tion for the mirror on the passenger side when reversing must be ena-
bled » page 45.
›
Switch on the ignition.
›
Press the required memory button
›
Adjust the rotary knob for the mirrors to the position  or in right-hand drive
to the position » page 74.
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position
›
Disengage reverse gear.
Fig. 59
Memory buttons and SET button
» page 74.
59.
button, press the desired memory
SET
» Fig. 59.
B
» page
The set position of the exterior mirror is stored.
Retrieving the saved setting
The retrieval is possible when turned the ignition is switched on and the vehi-
cle speed is less than 5 km/h or when the ignition key is inserted in the igni-
tion lock.
›
Press and hold the desired memory button
Stopping the ongoing adjustment
›
Press any button on the driver's seat.
Or
›
Press the button
Note
Each time you store the seat and exterior mirror settings for driving forward
you also have to re-store the setting of the exterior mirror on the passenger
side for reversing.
Memory function of the remote control key

Read and observe
The automatic storage of the driver's seat and exterior mirror positions when
locking the vehicle can be turned on in the memory of the remote control key
(afterwards only as function of automatic storage).
Enable automatic storage
›
Unlock the vehicle with the remote control key.
›
Press and hold any memory button
has assumed the position stored under this button, at the same time press
the button on the remote control key within 10 seconds.

The successful activation of the automatic storage function for each key is
confirmed by an acoustic signal.
Storing seat and exterior mirror settings for driving forward
›
Enable automatic storage.
74.
» Fig. 59
B
on the remote control key.

on page 75 first.
» Fig. 59 on page 77. After the seat
B
Seats and head restraints
for a short while.

77