Skoda 2014 Yeti Owner's Manual page 196

›
Uncouple any trailers.
›
Remove the vehicle tool kit » page 192
the boot.
Full wheel trim

Read and observe on page 193 first.
Extracting
›
Hook the clamp found in the vehicle tool kit
edge of the wheel trim.
›
Push the wheel wrench through the clamp, support on the tyre and pull off
the wheel trim.
Fitting
›
Press the wheel trim onto the wheel rim at the designated valve open-
ing » .
›
Then press the trim into the wheel rim until its entire circumference locks
correctly in place.
CAUTION
Use the pressure of your hand only, do not strike the full wheel trim. The
■
cover could be damaged.
When using the anti-theft wheel bolt, ensure that it is in the hole in the
■
valve area.
If wheel trims are fitted, it must be ensured that an adequate flow of air is
■
assured to cool the brake system. We recommend that you use child seats
from ŠKODA Original Accessories.
Wheel bolts
194
Do-it-yourself
and the spare wheel » page 188
» page 192 into the reinforced
Fig. 165
Remove the cap

Read and observe
from
Extracting
›
Push the extraction pliers
inner catches of the pliers are positioned at the collar of the cap.
›
Remove the cap in the direction of the arrow
Fitting
›
Push the caps onto the wheel bolts up to the stop.
The wheel bolt caps are housed in a plastic box in the spare wheel or in the
storage space for the spare wheel.
Changing a wheel

Read and observe
›
Remove the full wheel trim or the caps of the wheel bolts.
›
First of all slacken the anti-theft wheel bolt and then the other wheel bolts.
›
Jack up the vehicle until the wheel that needs changing is clear of the
ground.
›
Unscrew the wheel bolts and place them on a clean surface (cloth, paper,
etc.).
›
Remove the wheel carefully.
›
Attach the spare wheel and slightly screw on the wheel bolts.
›
Lower the vehicle.
›
Tighten the wheel bolts opposite each other using the wheel wrench (alter-
nating crosswise). Tighten the anti-theft wheel bolt last.
›
Replace the wheel trim or the caps.
WARNING
All bolts must be clean and must turn easily.
■
Under no circumstances grease or oil the wheel bolts!
■
When fitting unidirectional tyres, ensure that the direction of rotation is
■
correct » page 184.
Follow-up tasks

Read and observe
The following steps must also be performed after changing the wheel.
›
Stow and attach the replaced wheel in the spare wheel well using a special
bolt » page 188.
on page 193 first.
» page 192 sufficiently far onto the cap until the
» Fig. 165.
on page 193 first.
on page 193 first.
