Rear centre head restraints
Fig. 64 Rear center head restraint: Remove / Install
Read and observe
on page 80 first.
Applies to vehicles using the TOP TETHER system.
Removing/installing
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button
in the direction of arrow
A
the same time using a flat screwdriver with a max. width of 5 mm to press
the securing button in opening
›
Remove the restraint in the direction of arrow
›
To re-insert the head restraint, push it far enough down in the direction of
arrow
into the seat backrest until the locking button clicks into place.
4
Rear seats
Introduction
This chapter contains information on the following subjects:
» Fig. 64
1
in the direction of arrow
.
B
2
.
3
Setting theSetting the seats in the longitudinal direction
Fig. 65 Adjusting seats in forward/back direction
›
Pull lever
in the direction of arrow
A
rection of arrow
›
Move the seat to the desired position in the direction of arrow
inclination of the seat backrest
, while at
Fig. 66 Adjusting the seat backrest
81
›
Pull lever
on the lower portion in the direction of arrow
A
›
81
Adjust the desired inclination of the seat back in the direction of arrow
82
WARNING
82
Check for yourself that the seat backrest is engaged by pulling on it.
83
83
or on the release loop
1
» Fig.
65.
2
Seats and head restraints
in the di-
B
3.
» Fig.
66.
1
2.
81