Head Restraints - Skoda 2014 Yeti Owner's Manual

WARNING
The front passenger airbag should be switched off when transporting ob-
■
jects on the seat which was folded forwards
front passenger airbag.
Adjust the seat backrest only when the vehicle is stationary.
■
When moving the seat backrest, make sure the seat backrest has been
■
properly secured – check by pulling on the seat backrest.
If the seat backrest is folded, passengers may only be transported on the
■
outer seat behind the driver.
When moving the seat backrest, keep limbs out of the area between the
■
seat and seat backrest – risk of injury!
Never transport the following items on the seat backrest when folded
■
forwards.
Objects that could restrict the driver's view.
■
Objects which make it impossible for the driver to control the vehicle,
■
e.g. if they roll under the pedals, or could protrude into the driver's zone.
Objects which could lead to injury to passengers due to a change of di-
■
rection or braking manoeuvre when accelerating sharply.

Head restraints


Introduction
This chapter contains information on the following subjects:
Adjusting, installing and removing the headrests.
Rear centre head restraints
The head restraints and the front seats must be adjusted to match the body
size at all times and the seat belt must always be fastened properly to provide
the most effective levels of protection to the passengers
safe seated position.
Best protection is achieved if the top edge of the head rest is at the same level
as the upper part of your head.
WARNING
The head restraints must be correctly adjusted in order to offer effective
■
protection for the occupants in the event of an accident.
Never drive with the head restraints removed - risk of injury.
■
If the rear seats are occupied, the respective rear head restraint must not
■
be in the lower position.
80
Using the system
» page 20, Deactivating the
80
81
» page 7, Correct and
Note
The position of the front and rear outer head restraints is adjustable in height.
The middle rear head restraint is only adjustable in two positions.
Adjusting, installing and removing the headrests.
Fig. 63 Head restraint: Move up / move down

Read and observe on page 80 first.
Setting the height
›
Grasp the restraint and move upwards in the direction of
›
To move the restraint down, press the securing button
arrow and hold while at the same time pressing the restraint in the direc-
2
tion of arrow .
3
Removing/installing
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of the arrow
A
the head restraint out.
›
To re-insert the head restraint, push it far enough down into the seat back-
rest until the locking button clicks into place.
» Fig. 63.
1
in the direction of
A
» Fig. 63 and pull
2