Skoda 2014 Yeti Owner's Manual page 24

WARNING (Continued)
Pay particular attention to the information provided by the manufacturer
■
of the child safety seat regarding the correct routing of the belt. Seat belts
which are not correctly adjusted can themselves cause injuries even in mi-
nor accidents.
Safety belts must be checked to ensure that they are running properly.
■
One should also ensure that the belt is not damaged by sharp-edged fit-
tings.
The front passenger airbag must be deactivated if using a rear-facing
■
child seat on the front passenger seat. Further information
of a child seat on the front passenger seat.
CAUTION
When installing a child seat in which the child faces forward, adjust the head
■
restraints so that they are as high as possible.
If the head restraints still prevent the child seat from being installed, even in
■
the highest position, you will need to remove them
ing the child seat, re-install the head restraints.
Note
We recommend that you use child seats from ŠKODA Original Accessories.
These child seats were developed and also tested for use in ŠKODA vehicles.
They meet the ECE-R 44 standard.
Use of a child seat on the front passenger seat
Never use a backwards-facing child restraint system on a seat that is protec-
ted by an active airbag installed in front of it. This could cause the child severe
injury or even death.
22
Safety
» page 22, Use
» page 80. After remov-
Fig. 16
Sticker on the B column on the
front passenger side.
Fig. 17 Front passenger sun visor / label

Read and observe and
For safety reasons, we recommend that you install child seats on the rear
seats whenever possible.
The following instructions must be followed when using a child seat on the
front passenger seat.
›
The front passenger airbag must be deactivated if using a rear-facing child
seat » .
›
If possible, adjust the front passenger seat backrest so that it is as vertical,
so as to ensure secure contact between the passenger seat backrest and the
back of the child seat.
›
If possible, move the front passenger seat backwards so that there is no con-
tact between the front passenger seat and the child seat behind it.
›
With child safety seats in groups 2 or 3, make sure that the loop-around fit-
tings attached to the child seat headrest is positioned in front of or at the
same height as the loop-around fittings on the B pillar on the passenger side.
›
Set the height-adjustable front passenger seat as high up as possible.
›
Set the front passenger seat belt as high up as possible.
›
Place and fasten the child seat on the seat and the child in the child seat ac-
cording to the specifications in the manufacturer's user manual of the child
seat .
on page 21 first.
