Variable Loading Floor In The Luggage Compartment (Estate) - Skoda Octavia A7 Owner's Manual

Hide thumbs Also See for Octavia A7:
Table of Contents

Advertisement

Fig. 139 Removing light/inserting light
Read and observe
and
The lamp is for the illumination of the luggage compartment or it can be used
as a portable lamp.
The lamp is fitted with magnets. As a result, this can, for example, be fitted to
the vehicle body.
Description of the light
» Fig. 138
Button to turn the light that has been removed on / off
A
Part that lights up when the lamp is in the mount
B
Part that lights up when the lamp is not in the mount
C
If the light is in the mount, this will illuminate when the boot lid is opened.
To remove, hold the light in the area
» Fig.
139.
1
To switch on the removed light, press button
again will switch it off.
To insert, first of all insert the light with the rear part
» Fig. 139
and then push the light in the direction of arrow
clicks into place.
If the light is not switched off and is correctly inserted in the mount, the LED
diodes in the front part of the light
If the lamp is not correctly inserted into the holder, this does not light up when
the boot lid is opened and the rechargeable batteries are not charged.
on page 101 first.
and swivel in the direction of arrow
D
» Fig.
138. Pressing the light
A
into the mount
E
until it audibly
2
» Fig. 138
are automatically switched off.
C
Lamp charges
The lamp is supplied by three rechargeable type NiMH AAA batteries (voltage
1.2 V). The batteries are charged continuously with the engine running (to fully
charge the battery takes approximately 3 hours).
Replace batteries
» page
292.
CAUTION
The light is not waterproof, so it must be protected from humidity - otherwise
there is risk of damage.
Class N1 vehicles
Read and observe
and
In class N1 vehicles that are not fitted with a protective grille, a lashing set that
complies with the EN 12195 standard (1-4) must be used for fastening the load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.

Variable loading floor in the luggage compartment (Estate)

Positions of the variable loading floor
Fig. 140 Set variable loading floor to the upper position / variable load-
ing floor in the upper position
on page 101 first.
Transport of cargo
109

Advertisement

Table of Contents
loading

Table of Contents