Draytek Vigor2760 Series User Manual page 49

MTU
Default Route
Always On
Vigor2760 Series User's Guide
The following protocols are available when ADSL is chosen
as Profile Type.
The following protocols are available when VDSL is chosen
as Profile Type.
When PPPoE/PPPoA is selected
Username - Type in the username provided by ISP in this
field.
Password - Type in the password provided by ISP in this
field.
Confirm Password - Type in the password again for
confirmation.
PPP Authentication - Select PAP only or PAP or CHAP
for PPP.
PPP Fixed IP - Type a fixed IP address for PPP connection.
When Static/RFC1483_ROUTED /RFC1483 BRIDGE
under ADSL/VDSL is selected
IP Address – Type an IP address for the protocol.
Subnet Mask –Type a subnet mask value for the protocol.
Gateway – Type an IP address to the gateway for the
protocol
It means Max Transmit Unit for packet. The default setting
will be 1442 or 1500 based on the protocol you select.
Check the box to enable the default route for such WAN
profile.
If you want to connect to Internet all the time, check the
41