Draytek Vigor2760 Series User Manual page 111

End IP Address
Subnet Mask
MAC Address
MAC Binding
Vigor2760 Series User's Guide
Note: If you want to specify just a single IP address for
the object, you have to set the same IP address in the
fields of Start IP Address and End IP Address.
Type the end IP address if the Range type is selected.
Type the subnet mask if the Subnet type is selected.
Type the MAC address of the network card which will be
controlled if the MAC type is selected.
This setting changes slightly based on the Type (Range,
Subnet and MAC) you choose.
If you choose Range as the type and check the box of
MAC Binding, you have to specify a MAC Address of
this router in the related field.
The router will inspect if the MAC address of the
incoming packets matches with the specified MAC
address or not. If not, the packet will be block.
If you choose Subnet as the type and check the box of
MAC Binding, you have to specify a MAC Address of
this router in the related field.
The router will inspect if the MAC address of the
incoming packets matches with the specified MAC
address or not. If not, the packet will be block.
If you choose MAC as the type and check the box of
MAC Binding, you have to specify a range for IP
address in the related field (Start IP Address and End
IP Address).
If it is checked, and MAC is selected as the Type, the router
will inspect if the IP address of the incoming packets
matches with the specified IP address(es) or not. If not, the
103