CRAN KSHAFT /PISTON
• CYLINDER
I nspect the cylinder bores for wear or damage.
Measure the cylinder I.D. at three levels in X and Y
axis.
SERVICE LIMIT:
60.10
mm
(2.366
in)
Calculate the piston-to-cylinder clearance.
SERVICE LIMIT:
0.10
mm
(0.004
in)
Check the cylinder top surfaces for warpage with a
straight edge and feeler gauge_
SERVICE LIMIT:
0.10
mm
(0.004
in)
Oversize pistons and piston rings are available in
the following sizes:
0.25,0.50,0.75
and
1.00
mm
• CONNECTING ROD SMALL END
Measure the connecting rod small end I.D. If the
reading exceeds the service limit, replace the rod.
SERVICE LIMIT:
16_08
mm
(0.633
in)
Examine the rods for bends, cranks or other
damage.
Replace if necessary.
Calculate the connecting rod-to-piston pin clear-
ance.
SERVICE LIMIT:
0_06
mm
(0.002
in)
CRANKSHAFT REMOVAL
Separate the crankcase (page 10-3).
Remove the transmission.
Remove the connecting rods and pistons (page
10-5).
Remove the crankshaft and cam chains.
10-8
BOTTOM
CRANKSHAFT
~HONDA
~
V30 MAGNA
CAM CHAINS
Date of Issue: July, 1984
©
HONDA MOTOR CO., LTD.