HYDRAU
Lie
BRAKES
NOTE:
Check the fluid level often while bleeding
the system to prevent air from being pump-
ed into the system.
Use only DOT-3 or 4 brake fluid from a
sealed container.
Do not mix brake fluid types and never
reuse the contaminated fluid which has
been pumped out during brake bleeding,
because that would impair the efficiency
of the brake system.
When using a brake bleeding tool, follow
the manufacturer's operating instructions.
BRAKE FLUID FILLING WITH BRAKE
BLEEDER
Fill the reservoir to near full with recommended
brake fluid.
Connect the Mytyvac Brake Bleeder or equivalent
to the bleed valve.
Pump the brake bleeder and loosen the bleeder
valve.
Add fluid when the level in the master cylinder
reservoir is low.
NOTE:
If air entering the bleeder hose from around
the bleeder valve thread, seal the threads with
teflon tape.
Check the brake lever operation.
If the brake. feels spongy, bleed the air from the
system.
AIR BLEEDING
1. Squeeze the brake lever, then open the bleed
valve 1/2 turn and close the valve.
NOTE:
Do not release the brake lever until the bleed
valve has been closed.
2. Release the brake lever slowly and wait several
seconds after it reaches the end of its travel.
Repeat steps 1 and 2 until bubbles cease to appear
in the fluid at the end of the hose.
14-4
UPPER LVEL MARK
~HONDA
~V30MAGNA
Date of Issue: July, 1984
© HONDA MOTOR CO., LTD.