COOLING SYSTEM
SYSTEM TESTING
COOLANT
Remove the seat and left side cover.
Test the coolant mixture with an antifreeze tester.
For maximum corrosion protection, a
50-50%
solution of ethylene glycol and distilled water is
recommended.
RADIATOR CAP INSPECTION
Pressure test the radiator cap. Replace the radiator
cap if it does not hold pressure, or if relief pressure
is too high or too low. It must hold specified pres-
sure for at least six seconds.
NOTE:
Before install ing the cap on the tester, wet the
sealing surfaces.
RADIATOR CAP RELIEF PRESSURE:
75-105
kPa
(0.75-1.05
kg/cm
2
,
11-15
psi)
Pressurize the radiator, engine and hoses, and check
for leaks.
CAUTION
Excessive pressure can damage the radiator.
Do not exceed 105 kPa (1.05 kg/cm
2
,
15
psi).
Repair or replace components if the system will not
hold specified pressure for at least six seconds.
6-2
~HONDA
~V30
MAGNA
RADIATOR CAP
RADIATOR CAP TESTER
(COMMERCIALLY AVAILABLE IN U.S.A.)
RADIATOR CAP TESTER
(COMMERCIALLY AVAILABLE IN U.S.A.)
Date of Issue: July, 1984
©
HONDA MOTOR CO., LTD.