~HONDA
~V30
MAGNA
Connect the choke cable to the choke lever.
Align the left handlebar switch locating pin with
the hole in the handlebar and install the left handle-
bar switch.
Tighten the upper screw first, then tighten the lower
screw.
Place the clutch master cylinder on the handlebar
and install the master cylinder holder with the "UP"
mark facing up.
Align the holder mating surface with the punch
mark on the handlebar, and tighten the upper bolt.
Connect the clutch switch wires.
Connect the left and right handlebar switch wire
connectors.
FRONT WHEEL
REMOVAL
Raise the front wheel off the ground by placing a
support under the engine.
Disconnect the speedometer cable by removing the
set screw.
Date of Issue: July, 1984
©
HONDA MOTOR CO., LTD.
FRONT WHEEl/SUSPENSION/STEERING
CHOKE CABLE
"UP" MARK
PUNCH MARK
HOLDER
CLUTCH MASTER CYLINDER
SET SCREW
SPEEDOMETER CABLE
12-7