Transmission Installation - Suzuki GSF650A Service Manual

Transmission Installation

Install the transmission in the reverse order of removal.
Pay attention to the following points:
Bearing / Oil Seal
CAUTION
!
Replace the removed oil seal, bearings and
snap ring with new ones.
• Install the bearings (1), (2) with the special tool.
NOTE
• The stamped mark side of gearshift cam
bearing (1) faces inside.
• The sealed side of countershaft bearing (2)
faces outside.
Special tool
(A): 09913–70210 (Bearing installer set)
1
2
• Install the oil seal with the special tool.
B817H25206003
Special tool
• Apply grease to the oil seal lip.
GREASE A or equivalent)
• Apply a small quantity of thread lock to the oil seal
bolts and tighten them to the specified torque.
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
(A)
Push rod oil seal bolt (a): 12 N·m (1.2 kgf-m, 8.5
lbf-ft)
I718H1520016-02
(A)
I718H1520017-02
Manual Transmission:
(A): 09913–70210 (Bearing installer set)
: Grease 99000–25010 (SUZUKI SUPER
(A)
: Thread lock cement 99000–32110
(a)
5B-5
I718H1520018-02
I717H1520029-02