Suzuki GSF650A Service Manual page 247

2) Use the plastigauge to read the clearance at the
widest portion, which is specified as follows.
Special tool
(A): 09900–22301 (Plastigauge (0.025 -
0.076 mm))
(B): 09900–22302 (Plastigauge (0.051 -
0.152 mm))
(A), (B)
3) Install each camshaft journal holder to its original
position. Refer to "Engine Top Side Assembly
(Page 1D-26)".
4) Tighten the camshaft journal holder bolts in
ascending order of numbers to the specified torque.
Refer to "Engine Top Side Assembly (Page 1D-26)".
NOTE
Do not rotate the camshafts with the
plastigauge in place.
Tightening torque
Camshaft journal holder bolt: 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
5) Remove the camshaft journal holders and measure
the width of the compressed plastigauge using the
envelope scale.
6) This measurement should be taken at the widest
part of the compressed plastigauge.
Camshaft journal oil clearance (IN & EX)
Service limit: 0.150 mm (0.0059 in)
7) If the camshaft journal oil clearance exceeds the
limit, measure the inside diameter of the camshaft
journal holder and the outside diameter of the
camshaft journal. Replace the camshaft or the
cylinder head depending upon which one exceeds
the specification.
Special tool
I718H1140083-04
mm))
35 mm))
Camshaft journal holder I.D. (IN & EX)
Standard: 24.012 – 24.025 mm (0.9454 – 0.9459
in)
Special tool
Camshaft journal O.D. (IN & EX)
Standard: 23.959 – 23.980 mm (0.9433 – 0.9441
in)
I718H1140084-01
Engine Mechanical:
(C): 09900–20602 (Dial gauge (1/1000 mm, 1
(D): 09900–22403 (Small bore gauge (18 –
(E): 09900–20205 (Micrometer (0 – 25 mm))
(D)
(E)
1D-35
I718H1140085-01
(C)
I718H1140086-01
I649G1140204-03