Clutch Hose Removal And Installation - Suzuki GSF650A Service Manual

5C-5 Clutch:
7) Loosen the air bleeder valve and pump the clutch
lever until old clutch fluid flows out of the bleeder
system.
8) Close the air bleeder valve and disconnect a clear
hose.
Tightening torque
Air bleeder valve (Clutch) (a): 6 N·m (0.6 kgf-m,
4.5 lbf-ft)
9) Fill the reservoir with new fluid to the upper mark of
the reservoir.
10) Reinstall the removed parts.
I718H1530010-01
(a)
I717H1530029-01

Clutch Hose Removal and Installation

Removal
1) Drain clutch fluid. Refer to "Clutch Fluid
Replacement (Page 5C-4)".
2) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
3) Remove the left frame cover and engine sprocket
outer cover. Refer to "Exterior Parts Removal and
Installation (GSF650/S/A/SAK7) in Section 9D
(Page 9D-6)" and "Engine Sprocket Removal and
Installation in Section 3A (Page 3A-2)".
4) Remove the clutch hose as shown in the clutch hose
routing diagram. Refer to "Clutch Hose Routing
Diagram (Page 5C-2)".
Installation
1) Install the clutch hose as shown in the clutch hose
routing diagram. Refer to "Clutch Hose Routing
Diagram (Page 5C-2)".
2) Bleed air from the clutch system. Refer to "Air
Bleeding from Clutch Fluid Circuit (Page 5C-3)".
3) Reinstall the removed parts.
B817H25306006