Suzuki GSF650A Service Manual page 46

0B-13 Maintenance and Lubrication:
6) Turn off the engine and wait about three minutes,
then check the oil level through the inspection
window (3). If the level is below the "L" mark, add oil
to the "F" mark. If the level is above the "F" mark,
drain the oil until the level reaches the "F" mark.
3
Oil Level Inspection
1) Keep the motorcycle upright with the center stand.
2) Start up the engine and allow it to run for several
minutes at idling speed.
3) Turn off the engine and wait about three minutes,
then check the oil level through the inspection
window (1). If the level is below mark "L", add oil to
"F" level. If the level is above mark "F", drain oil to "F"
level.
1
Oil Filter Replacement
1) Drain engine oil as described in the engine oil
replacement procedure.
2) Remove the oil filter (1) using the special tool.
NOTE
Remove the oil filter from the left side of the
vehicle. Push the radiator hose aside if it
interferes with the removal operation.
Special tool
(A): 09915–40610 (Oil filter wrench)
3) Apply engine oil lightly to the O-ring of new oil filter,
before installation.
CAUTION
!
I717H1020040-02
ONLY USE A GENUINE SUZUKI
MOTORCYCLE OIL FILTER.
Other manufacturer's oil filters may differ in
thread specifications (thread diameter and
pitch), filtering performance and durability
which may lead to engine damage or oil
leaks. Also, do not use a genuine Suzuki
automobile oil filter on this motorcycle.
4) Install a new oil filter. Turn it by hand until you feel
that the oil filter O-ring contacts the oil filter mounting
surface. Then, tighten the oil filter two full turns (or to
specified torque) using the special tool.
NOTE
To properly tighten the oil filter, use the
special tool. Never tighten the oil filter by
hand only.
Special tool
Tightening torque
Oil filter (a): 20 N·m (2.0 kgf-m, 14.5 lbf-ft)
I717H1020041-03
1
(A): 09915–40610 (Oil filter wrench)
1
(a)
(A)
I717H1020009-01
(A)
I718H1020026-01