Suzuki GSF650A Service Manual page 603

10) Install the spring washer seat (12) and spring washer
(13) onto the clutch sleeve hub correctly.
12
11) Insert the clutch drive plates and driven plates one
by one into the clutch sleeve hub in the prescribed
order.
NOTE
Insert the outermost No.2 drive plate claws
"A" to the other slits "B" of clutch housing as
shown.
14
14. No.3 drive plate
15. No.1 drive plate
16. No.2 drive plate
13
I718H1530051-01
"B"
"A"
I717H1530020-01
15
16
"C"
17
18
I717H1530021-02
17. No.1 driven plate (5 – 7 pcs)
: The No.1 and No.2 driven plates
are 7 in total.
18. No.2 driven plate (0 – 2 pcs)
: The No.1 and No.2 driven plates
are 7 in total.
"C": Direction of outside
NOTE
For drive plate
Three kinds of the drive plate (No.1, No.2 and
No.3) are equipped in the clutch system, they
can be distinguished by the inside diameter
and paint "D".
Drive plate I.D.
No.1 101 mm (5.0 in)
No.2 101 mm (5.0 in)
No.3 108 mm (5.3 in)
NOTE
For driven plate
Two kinds of the driven plate (No.1 and No.2)
are equipped in the clutch system, they can
be distinguished by the thickness. The No.1
and No.2 driven plates are 7 in total. The
driven plate No.2 should be used within 2
pcs. The driven plate No.2 should be installed
pressure plate side.
Driven plate
No.1
No.2
12) Install the clutch springs.
• Tighten the clutch spring set bolts to the specified
torque.
NOTE
Tighten the clutch spring set bolts diagonally.
Tightening torque
Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lbf-
ft)
Clutch: 5C-16
"D"
I717H1530035-03
Paint "D"
Black
Green
—
Thickness
2.6 mm (0.10 in)
2.3 mm (0.09 in)
I717H1530022-02