Suzuki GSF650A Service Manual page 618

6B-7 Steering / Handlebar:
4) Remove the cable guides (2).
5) Dismount the handlebars and steering upper
bracket. Refer to "Ignition Switch Removal and
Installation in Section 1H (Page 1H-7)".
NOTE
If necessary, remove the ignition switch from
the upper bracket. Refer to "Ignition Switch
Removal and Installation in Section 1H
(Page 1H-7)".
6) Remove the steering stem nut using the special tool.
NOTE
When loosening the stem nuts, hold the
steering stem lower bracket to prevent it from
falling.
Special tool
(A): 09940–14911 (Steering stem nut
wrench)
7) Remove the steering stem lower bracket.
(A)
2
I717H1620019-01
I717H1620023-02
8) Remove the dust seal (3) and steering stem upper
bearing (4).
3
Installation
Install the steering in the reverse order of removal.
Pay attention to the following points:
Bearing
• Apply SUZUKI SUPER GREASE to the bearings,
races and dust seals before remounting the steering
stem.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
I717H1620024-02
I717H1620025-01