Suzuki GSF650A Service Manual page 321

3) Install a new mechanical seal using a suitable size
socket wrench.
CAUTION
!
Replace the mechanical seal with a new one.
NOTE
On the new mechanical seal, the sealer "A"
has been applied.
4) Apply GREASE to the impeller shaft.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5) Install the impeller shaft and washer (1) to the water
pump body.
"A"
I718H1160058-01
I718H1160059-01
1
I718H1160017-01
Engine Cooling System:
6) Install the rubber seal (2) into the impeller.
7) After wiping off the oily or greasy matter from the
mechanical seal ring (3), install it into the impeller.
NOTE
The paint marked side "B" of mechanical seal
ring faces the rubber seal.
"B"
3
8) Install the washer (4) and seal washer (5) onto the
impeller securing bolt.
NOTE
The metal side "C" of seal washer and the
curved side "D" of washer face the impeller
securing bolt head.
"C"
9) Install the impeller (6) and tighten the impeller
securing bolt to the specified torque.
Tightening torque
Impeller securing bolt (a): 8 N·m (0.8 kgf-m, 6.0
lbf-ft)
1F-15
2
I718H1160018-01
5
4
"D"
I718H1160019-02
6
(a)
I718H1160021-02