Suzuki GSF650A Service Manual page 443

9) Loosen the rear axle nut (7) .
10) Loosen the chain adjuster bolts (8) to provide
additional chain slack, left and right.
7
8
11) Remove the spacer (9) engine sprocket (10).
10
Installation
Install the engine sprocket in the reverse order of
removal. Pay attention to the following points:
• Install the spacer and engine sprocket.
• Apply Thread lock super to the driveshaft.
: Thread lock cement 99000–32030 (Thread
Lock Cement Super 1303 or equivalent)
• Tighten the engine sprocket nut (1) to the specified
torque.
Tightening torque
Engine sprocket nut (a): 115 N·m (11.5 kgf-m, 83.0
lbf-ft)
8
I717H1310008-01
9
I717H1310009-01
1
(a)
I717H1310010-01
Drive Chain / Drive Train / Drive Shaft:
• Apply a small quantity of Thread lock to the speed
sensor rotor bolt (2).
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
• Tighten the speed sensor rotor bolt (2) to the specified
torque.
Tightening torque
Speed sensor rotor bolt (b): 25 N·m (2.5 kgf-m,
18.0 lbf-ft)
• Before installing the engine sprocket inner cover,
apply a small quantity of suzuki super grease to the
clutch push rod.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the engine sprocket inner cover (3).
NOTE
Fit the clamp to the bolt "A".
• Tighten the speed sensor mounting bolt (4) to the
special torque.
Tightening torque
Speed sensor mounting bolt (c): 6.5 N·m (0.65
kgf-m, 4.7 lbf-ft)
"A"
3A-3
2
(b)
I717H1310011-02
4
(c)
3
I717H1310012-01