Drive Chain Replacement - Suzuki GSF650A Service Manual

2) Install the bearing to the sprocket mounting drum
using the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
3) Install the dust seal using the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
4) Apply grease to the dust seal lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
(B)
5) Apply grease to the retainer before installing the rear
sprocket mounting drum.
(A)

Drive Chain Replacement

Use the special tool in the following procedures, to cut
and rejoin the drive chain.
I717H1310027-01
Special tool
tool)
Drive Chain Cutting
I717H1310028-01
I717H1310029-01
Drive Chain / Drive Train / Drive Shaft:
6) Install the rear sprocket mounting drum assembly to
rear wheel. Refer to "Front Wheel Dust Seal /
Bearing Removal and Installation in Section 2D
(Page 2D-7)".
7) Install the rear wheel assembly. Refer to "Rear
Wheel Assembly Removal and Installation (GSF650/
S/U/SUK7) in Section 2D (Page 2D-11)".
NOTE
When using the special tool, apply a small
quantity of grease to the threaded parts of
the special tool.
: 09922–22711 (Drive chain cutting and joining
1) Set up the special tool as shown in the illustration.
8
6
7
1. Tool body
2. Grip handle
3. Pressure bolt [A]
4. Pressure bolt [B]
5. Bar
6. Adjuster bolt (With through hole)
7. Pin remover
8. Chain holder (Engraved mark 500) with reamer bolt M5 x 10
3A-7
B817H23106006
I649G1310023-02
1
4
5
3
2
I649G1310024-02