Suzuki GSF650A Service Manual page 561

1) Remove the seat and frame covers. Refer to
"Exterior Parts Removal and Installation (GSF650/S/
A/SAK7) in Section 9D (Page 9D-6)".
2) Remove the battery (1). Refer to "Battery Removal
and Installation in Section 1J (Page 1J-12)".
3) Remove the starter relay (2) from the battery case.
4) Remove the cooling fan relay (3) and fuel pump
relay (4) from the battery case.
5) Remove the battery case.
3
2
6) Drain the brake fluid. Refer to "Brake Fluid
Replacement in Section 4A (Page 4A-7)".
7) Loosen the flare nuts (5) and disconnect the brake
pipes.
8) Disconnect the ABS control unit coupler (6).
6
5
9) Remove the reservoir mounting bolt. Refer to "Rear
Brake Master Cylinder Assembly Removal and
Installation in Section 4A (Page 4A-13)".
10) Remove the ABS control unit/HU by removing the
mounting bolts.
1
4
I717H2450030-02
5
I717H2450031-01
I717H2450032-01
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
CAUTION
!
• Route the brake hoses and pipes correctly.
Refer to "Front Brake Hose Routing
Diagram (GSF650) in Section 4A (Page 4A-
1)", "Front Brake Hose Routing Diagram
(GSF650S) in Section 4A (Page 4A-2)" or
"Rear Brake Hose Routing Diagram in
Section 4A (Page 4A-3)".
• Make sure to hold the brake pipe when
tightening the flare nut, or it may be
misaligned.
• Tighten the brake pipe flare nuts to the specified
torque.
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kgf-m, 11.5
lbf-ft)
(a)
• Bleed air from the brake fluid circuit. Refer to "Air
Bleeding from Brake Fluid Circuit in Section 4A
(Page 4A-5)".
ABS: 4E-74
I717H2450033-01
(a)
I717H2450034-01