• Pass the chain between the oil pump drive and driven
sprockets.
• Install the spacer (8).
"C"
7
• Reinstall the clutch. Refer to "Clutch Installation in
Section 5C (Page 5C-14)".
Oil Pump Inspection
Inspect the oil pump in the following procedures:
1) Remove the oil pump. Refer to "Oil Pump Removal
and Installation (Page 1E-10)".
Service Data
Oil Pump
Item
Oil pressure (at 60 °C, 140 °F)
Oil
Item
Engine oil type
Engine oil capacity
Tightening Torque Specifications
Fastening part
Main Oil gallery plug (M16)
Oil gallery plug (M12)
Oil pressure switch
Oil pressure switch lead wire bolt
Piston cooling oil jet bolt
Oil gallery jet
Oil pump mounting bolt
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List in Section 0C
(Page 0C-7)".
8
I718H1150062-01
B817H21506011
Specifications
(1.0 – 4.0 kgf/cm
SAE 10W-40, API SF/SG or SH/SJ with JASO MA
Change
Filter change
Overhaul
N⋅m
35
15
14
1.5
10
22
10
Engine Lubrication System:
2) Rotate the oil pump by hand and check that it moves
smoothly. If it does not move smoothly, replace the
oil pump assembly.
CAUTION
!
Do not attempt to disassemble the oil pump
assembly.
The oil pump is available only as an
assembly.
3) Install the oil pump. Refer to "Oil Pump Removal and
Installation (Page 1E-10)".
Standard
100 – 400 kPa
2
, 14 – 57 psi)
at 3 000 r/min
Specification
3 000 ml (3.2/2.6 US/lmp qt)
3 500 ml (3.7/3.1 US/lmp qt)
3 700 ml (3.9/3.3 US/lmp qt)
Tightening torque
kgf-m
lbf-ft
3.5
25.5
1.5
11.0
1.4
10.0
0.15
1.1
1.0
7.0
2.2
16.0
1.0
7.0
1E-12
I718H1150063-01
B817H21507001
Limit
—
Note
B817H21507002
Note
(Page 1E-4)
(Page 1E-5)
(Page 1E-7)
(Page 1E-7)
(Page 1E-9)
(Page 1E-9)
(Page 1E-11)