Suzuki GSF650A Service Manual page 372

1J-10 Charging System:
2) Remove the caps (2) from the electrolyte container.
NOTE
• Do not remove or pierce the sealed areas
"B" of the electrolyte container.
• After filling the electrolyte completely, use
the removed cap (2) as sealing caps of
battery-filler holes.
2
3) Insert the nozzles of the electrolyte container (3) into
the electrolyte filler holes of the battery.
4) Hold the electrolyte container firmly so that it does
not fall.
NOTE
Do not allow any of the electrolyte to spill.
3
5) Make sure that air bubbles (4) rise to the top of each
electrolyte container, and leave in this position for
about more than 20 minutes.
4
"B"
I649G11A0040-03
I649G11A0041-03
I649G11A0042-03
NOTE
If no air bubbles are coming up from a filler
port, tap the bottom of the electrolyte
container two or three times.
Never remove the container from the battery.
6) After confirming that the electrolyte has entered the
battery completely, remove the electrolyte containers
from the battery.
7) Wait for about 20 minutes.
8) Insert the caps (2) into the filler holes, pressing in
firmly so that the top of the caps do not protrude
above the upper surface of the battery's top cover.
CAUTION
!
• Once install the caps to the battery, do not
remove the caps.
• Do not tap the caps with a hammer when
installing them.
I310G11A0024-01
2
I718H11A0027-01