Rear Wheel Drive Assembly And Swingarm; Engine Removal - Yamaha YFM250XL(C) Service Manual

4

ENGINE REMOVAL

REAR WHEEL DRIVE ASSEMBLY AND
SWINGARM
1.Disconnect:
Breather hose 1 (final gear housing and
rear brake drum)
(from the cable guides 2 of main frame)
2.Block the front wheels, and elevate the
rear wheels by placing the suitable stand
under the frame.
3.Remove:
Bolt 1 (rear shock absorber-top)
4.Remove:
Clamps 1 (rubber boot)
Pivot shaft caps 2
Locknuts 3 (pivot shaft)
Pivot shafts 4 (swingarm)
5.Remove:
Rear wheel drive assembly/swingarm
CAUTION:
When removing the swingarm, hold the
shock absorber so that it may not fall over.
When the swingarm is disconnected from
the rubber boot, the drive shaft may fall
off. Be careful not to lose these parts.
ENGINE REMOVAL
1.Remove:
Bolts 1 (engine mounting - top)
Bolt 2 (engine mounting - front)
Bolt 3 (engine mounting - rear upper)
Bolt 4 (engine mounting - rear lower)
2.Remove:
Engine assembly (to right side)
4 - 4
ENG