Installation - Yamaha YFM250XL(C) Service Manual

7
REAR SHOCK ABSORBER AND SWINGARM
Remove the bearings 3 using a general
bearing puller.
Install the new bearings and oil seal by
reversing the previous steps.
NOTE:
Use a socket 4 that matches the outside
diameter of the race of the bearing and oil
seal.
CAUTION:
Do not strike the center race 5 or balls 6
of the bearing. Contact should be made
only with the outer race 7.
*********************************

INSTALLATION

Reverse the "REMOVAL" procedures.
Note the following points.
1.Lubricate:
Bearings 1
Oil seals 2
Collars 3
Pivot shafts 4
Lithium-soap base grease
2.Install:
Swingarm
Rear axle housing
Pivot shafts (swingarm)
7 - 40
CHAS