Yamaha YFM250XL(C) Service Manual page 262

7
FRONT SHOCK ABSORBER AND FRONT ARM
NOTE:
Do not loosen the axle nut after torque
tightening. If the axle nut groove is not
aligned with the cotter pin hole, align
groove with the hole by tightening up on
the axle nut.
WARNING
Always use a new cotter pin.
10.Install:
Brake shoe plate
Brake drum
Front wheel
Refer to the "FRONT WHEELS AND
FRONT BRAKE-INSTALLATION" section.
11.Adjust:
Toe-in
Refer to the "TOE-IN ADJUSTMENT" sec-
tion in CHAPTER 3.
12.Install:
Front fender
Front bumper
Front carrier
Refer to the "FENDERS AND FUEL TANK-
FRONT FENDER - Installation" section in
CHAPTER 3.
7 - 34
CHAS