Yamaha YFM250XL(C) Service Manual page 390

1 Rear brake cable
2 Throttle cable
3 Wire harness
4 Starter motor lead
5 Tail/brake light lead
È Route the throttle cable and rear brake cable
through the cable guide. Make sure that the
throttle cable is routed to the inside of the rear
brake cable.
É Fasten the wire harness to the frame with the
plastic clamps.
CABLE ROUTING
Ê Make sure the starter motor lead and wire har-
ness do not contact the ignition coil.
Ë Fasten the wire harness, starter motor lead, and
ignition coil lead to the frame with the plastic
locking tie.
Ì Route the taillight lead through the lead holders
on the lid and the bottom of the storage box.
Í 50 mm (2.0 in)
– 11 –
SPEC