Yamaha YFM250XL(C) Service Manual page 253

STEERING SYSTEM
2.Lubricate:
Steering bearings 1
Oil seals 2
Lithium-soap base grease
3.Install:
Oil seals 1 (to steering shaft)
Collars 2
Steering bearings 3
NOTE:
Be careful not to damage the oil seals dur-
ing installation.
4.Install:
Steering shaft 1 (with steering bearings)
WARNING
Make sure the brake cables and leads are
properly routed, and are not damaged or
twisted.
5.Install:
Tie-rods (left and right)
NOTE:
Be sure that the rod-end 1 on the indenta-
tion 2 side is connected to the knuckle arm.
6.Tighten:
Nuts 1 (tie-rod end)
Nut (tie-rod):
25 Nm (2.5 m • kg, 18 ft • lb)
7 - 25
CHAS
7