FINAL DRIVE
Press the bearing onto the pinion gear shaft with the
special tools shown.
~HONDA
~Gl1200D'GlI200A
DRIVER
07746-0030100
Place the pinion assembly into the gear housing.
Drive the pinion assembly into the gear case until
pinion retainer threads can engage with the case
threads.
Apply gear oil to the O-ring and threads on the
pinion retainer.
Screw in the pinion retainer to press the pinion
bearing into place, then tighten
it
to the specified
torque.
TORQUE:
100-120 N'm (10.0-12.0 kg-m. 72-87 ft-Ib)
RING GEAR ASSEMBLY
Install the original spacer onto the ring gear.
NOTE:
If the gear set, pinion bearing, ring gear bear-
ing and/or gear case is replaced, install a 2.0
mm thick spacer.
Place the ring gear bearing over the ring gear shaft.
14-10
ATTACHMENT, 30 mm I.D.
07746-0030300
RING GEAR SPACER
PINION RETAINER WRENCH
0791 O-M
E80,;:O~O:::O
. .