Lights/Switches/Instruments; Lights/Switches/Instruments Service Information; Lights/Switches/Instruments Tools - Honda Gold Wing GL1200D Shop Manual

.-
a
HONDA
~GL1200D'GL1200A
19. lIGHTS/SWITCH[S/INSTRUM[NTS
SERVICE INFORMATION
HEADLIGHT
INSTRUMENTS
BULB REPLACEMENT
OIL PRESSURE WARNING SWITCH
BRAKE SWITCHES
GEARSHIFT SENSOR
HANDLEBAR SWITCHES
IGNITION SWITCH
SERVICE INFORMATION
GENERAL
19-1
19-2
19-4
19-7
19-10
19-10
19-11
19-11
19-14
CLUTCH SWITCH
TEMPERATURE GAUGE
FUEL GAUGE
THERMOSTATIC SWITCH
BRAKE AND TAIL LIGHT SENSOR
BRAKE LIGHT RELAY
FUEL PUMP RELAY
SELF CANCELLING TURN SIGNAL
SYSTEM
L.C.D. METER
19-15
19-16
19-17
19-18
19-19
19-20
19-20
19-21
19-25
• Some wires have different colored bands around them near the connector. These are connected to other wires which cor-
respond with the band color.
• All plastic plugs have locking tabs that must be released before disconnecting, and must be aligned when reconnecting.
• The following color codes are indicated throughout this section and on the wiring diagram.
Bu =Blue
BI :Black
Sr :Brown
G =Green
Gr =Grey
Lb
=
Light Blue
Lg
=
Light Green
o
"Orange
P -Pink
A
-=
Red
W = White
Y - Yellow
• To isolate an electrical failure, check the continuity of the electrical path through the part. A continuity check can usually
be made without removing the part from the motorcycle. Simply disconnect the wires and connect a continuity tester or
volt·ohmmeter to the terminals or connections.
• A continuity tester is useful when checking to find out whether or not there is an electrical connection between the two
points. An ohmmeter is needed to measure the resistance of a circuit, as when there is a specific coil resistance involved, or
when checking for high resistance by corroded connections.
TOOLS
Special
Fuel unit wrench
07920-5820000
19-1