Gear Tooth Contact Pattern Check - Honda Gold Wing GL1200D Shop Manual

FINAL DRIVE
~HONDA
~GL1200D'GL120DA
Remove the ring gear. If the clearance exceeds the
service limit, heat the gear case cover to approxi-
mately BOcC (176°F) and remove the stop pin by
tapping the cover.
CAUTION:
A/ways wear gloves when handling the gear
case after it has been heated.
Install a stop pin shim to obtain the correct clear-
ance.
SHIM THICKNESS: A: 0.10
mm
(0,004
in)
8; 0.15
mm
(0.006
in)
Install the shim and drive the stop pin into the case
cover.
STOP PIN
-~
STOP PIN SHIM
Clean all sealing material off the mating surface of
the gear case and cover.
NOTE:
Keep dust and dirt out of the gear case.
Be careful not to damage the mating sur-
faces.
Apply liquid sealant to the mating surface of the
gear case cover.
GEAR TOOTH CONTACT PATTERN
CHECK
Apply a thin coat of Prussian Blue to the pinion
gear teeth for a gear tooth contact pattern check.
Place the wave washer onto the ring gear.
Apply gear oil to the lip of the oil seal in the final
gear case.
Install the ring gear into the gear case.
CAUTION:
Be careful not to damage the gear case oil
seal lip by ring gear shaft.
14-12
PRUSSIAN BLUE
WAVE WASHER