Hydraulic Tappet Adjuster Inspection - Honda Gold Wing GL1200D Shop Manual

~HONDA
~GL1200D'GL1200A
HYDRAULIC TAPPET ADJUSTER
INSPECTION
Inspect the hydraulic tappet adjuster for wear or
damage or for a clogged oil hole.
Measure the compression stroke of each hydraulic
tappet adjuster
35
follows:
Attach the Hydraulic Tappet Bleeder to the hydrau-
lic tappet and compress and extend the adjuster
slowly in a jar filled with kerosene.
NOTE:
Hold the adjuster upright while compressing
and extending the adjuster.
Continue operating the adjuster until there are no
air bubbles from the adjuster and
it
does not make
no further action.
Remove the adjuster and try to compress quickly
the adjuster by hand. Measure the compression
stroke with the dial gauge on the flat place.
COMPRESSION STROKE: 0-0.3 mm (0-0.012 in)
NOTE:
Keep the adjuster below the surface of
kerosene while priming the adjuster.
CYLINDER HEADIVALVE
HYDRAULIC TAPPET ADJUSTER
HYDRAULIC TAPPET BLEEDER
DIAL GAUGE
07973-MJOOOOO
I
or0797~ME90000
~
~-
~J
..,
U
~~
>p,
l!J
§
I
('
P~
----
HYDRAULIC TAPPET ADJUSTER
7 -11