ALTERNATOR/STARTER CLUTCH/REAR ENGINE COVER
~HONDA
~GL1200D'GL1200A
REAR ENGINE COVER DISASSEMBLY
Unscrew the three screws attaching the stator and
remove the plate.
SCREW
GROMMET
PULSE GENERATOR CASE
Pry off the circlip securing the alternator wire, and
remove the stator.
Remove the three bolts and then remove the pulse
generator case and spacer.
CIRCLIP
BOLTS
OUTPUT SHAFT BEARING
Inspect the oil seals and bearings for the output
shaft and pulse generator drive shaft.
Remove the oil seals and bearings from the case and
replace with new ones
if
necessary.
PULSE GENERATOR
DRIVE SHAFT BEARING
9-4