Nuts, Bolts, Fasteners - Honda Gold Wing GL1200D Shop Manual

~HONDA
~GLI2000'GL1200A
Aemove the three screws and remove the drier
cover.
Remove the spring and spring seat.
Remove the retainer plate and felt packing.
Discard the desiccant.
Remove the felt and sponge packings and retainer
plate.
Clean the inside of thll drier body with clean cloth.
Install the retainer plate, sponge packing and felt
packing.
Pack the new desiccant and install the felt packing.
Install the retainer plate, and spring seat.
Clean and dry the sponge filter.
Install the sponge filter into the drier cover.
Install the drier cover alJd tighten the screws
securely.
Install the drier and right fairing pocket.
NUTS, BOLTS, FASTENERS
Check that all chassis nuts and bolts are tightened
to their correct torque values (Page 1·6) at the
intervals shown in the Maintenance Sdledule
(Page 3-4).
Check all coner pins, safety clips, hose clamps and
cable stays.
MAINTENANCE
~'----BODY
~'_'-----RETAINER
PLATE
@-·-----SPONGEPACKING
FELT
~O"'_---DESICCANT
PACKINGS~i
Q
~,_.~
RETAINER PLATE
5);~_---SPRING
O-RING
~r-._---SPRING
SEAT
~ g-·~----SPONGE
FILTER
&~
I
GOVER
3-21